Solid State Logic Soundscape Mixer Manual de usuario descargar pdf (Pagina 30)

Soundscape Mixpander

Page 30 of 109

For mono in‐stereo out, the input is mono, but the input signal needs to reach both inputs of a

stereo output element. This mixer column configuration should only be created in order to use a

stereo process or effect on a mono source (e.g., a mono to stereo chorus or reverb). In fact, if you

use this configuration without inserting a mono to stereo process in the mixer column, then the

input element will not be connected to input 2 of the output element, and this should be avoided

as it can have undesirable effects (the right hand side channel of the output element may pick up a

signal from elsewhere in the Mixer). In the example below, a mono signal reaches the mixer

column via input 1. A mono to stereo reverb effect is applied. The reverb’s stereo pair of outputs

connects as required to the stereo output element.

A typical mono in - stereo out mixer

column, as seen within the Mixer.

The same mixer column, presented

as a connection diagram.

1 2

A A

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 108 109

Sin comentarios

Solid State Logic Soundscape Mixer Manual de usuario Pagina 30