Solid-state-logic XLogic Delta LINK MADI HD Manual de usuario descargar pdf (Pagina 13)

1. In a typical setup, connect Primary Port A of the Delta-Link MADI HD to the Primary Port of your HD Core card and

Primary Port B of the Delta-Link MADI HD to the Primary Port of your first HD Accel card via DigiLink cables supplied.

Technically, any Primary Port of the Delta-Link MADI HD is compatible with any Primary Port of a Pro Tools

system, however, connecting Primary Ports A and B of the Delta-Link MADI HD to consecutively numbered Primary

Ports of the Pro Tools

HD system is preferable in order to maintain clarity when working in the I/O Setup page of the

Pro Tools

software.

2. Connect a suitable Word or Frame clock source to the WordClock input at the rear of the Delta-Link MADI HD.

(see overleaf)

3. Connect the mains cable to the mains connector of the Delta-Link MADI HD.

4. External devices may now be connected to the MADI inputs and outputs.

5. Power up the computer that hosts your Pro Tools

system, and power up the Delta-Link MADI HD (using the power

switch on the front panel).

WARNING!

Do not connect or disconnect the Delta-Link MADI HD to/from the Pro Tools

cards or power cycle the unit

while the Pro Tools

software is running. Doing so will loose all interface settings, recovery from which will

require each option to be toggled on the Pro Tools I/O set up page – refer to Section 6.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Sin comentarios

Solid-state-logic XLogic Delta LINK MADI HD Manual de usuario Pagina 13